EC2622 – Micropower CMOS Output Hall Effect Switch

General description

EC2622 Hall-effect sensor is a temperature stable, stress-resistant, Low Tolerance of Sensitivity micro-power switch. Superior high-temperature performance is made possible through a dynamic offset cancellation that utilizes chopper-stabilization. This method reduces the offset voltage normally caused by device over molding, temperature dependencies, and thermal stress.EC2622 is special made for low operation voltage, 1.65V, to active the chip which is includes the following on a single silicon chip: voltage regulator, Hall voltage generator, small-signal amplifier, chopper stabilization, Schmitt trigger, CMOS output driver. Advanced CMOS wafer fabrication processing is used to take advantage of low-voltage requirements, component matching, very lowinput-offset errors, and small component geometries. This device requires the presence of omni-polar magnetic fields for operation.The package type is in a Halogen Free version has been verified by third party Lab.


lCMOS Hall IC Technology

lStrong RF noise protection

l1.65 to 3.5V for battery-powered applications

lOmni polar, output switches with absolute value of North or South pole from magnet

lOperation down to 1.65V, Micro power consumption

lHigh Sensitivity for reed switch replacement applications Direction detection

lLow sensitivity drift in crossing of Temp. range

lUltra Low power consumption at 5uA (Avg)

lHigh ESD Protection, HBM > ±4KV( min )

lOperation with South Pole (OUT1) or North Pole (OUT2)

lTotem-pole output


lSolid state switch

lHandheld Wireless Handset Awake Switch

( FlipCell/PHS Phone/Note Book/Flip Video Set)

lMagnet proximity sensor for reed switch replacement in

low duty cycle applications

lWater Meter

lPDA          lPDVD

lNB             lPab PC

Pin Configurations


Ordering info

Typical Applications circuit